Lat 26 Carbon Guard MSDS
|
LAT-CG1; LAT-CG16; LAT-CG32 |
|
|
Date Prepared: |
04/26/2017 |
Safety Data Sheet
Section 1. Identification
Manufacturer:
Lat 26˚
205 SW 30th Street
Fort Lauderdale, FL 33315
1-754-206-2356
For Hazardous Materials [or Dangerous Goods] Incident
Spill, Leak, Fire, Exposure, or Accident
Call CHEMTREC Day or Night
1-800-424-9300 / +1 703-527-3887 CCN815696
Product Identification: LAT26 Carbon Guard
Suggested Use: Apply to exterior marine vehicle surfaces to enhance gloss and protect from damaging environmental elements.
Section 2. Hazard(s) Identification
|
Hazard Class & Category Codes |
Hazard Statement Codes |
Pictograms & Signal Words |
|
Asp. Tox. 1 |
H304: May be fatal if swallowed or enters airways |
Danger |
|
Skin Irrit. 2 |
H315: Causes skin irritation. |
|
|
Eye Irrit. 2 |
H319: Causes serious eye irritation |
|
|
|
|
|
Precautionary Statements Codes |
Precautionary Statements |
|
P101 |
If medical advice is needed, have product container or label at hand |
|
P102 |
Keep out of reach of children |
|
P103 |
Read label before use |
|
P262+280 |
Do not get in eyes, on skin, or on clothing; Wear protective gloves/protective clothing/eye protection/face protection. |
|
P332+313 |
If skin irritation occurs: Get medical advice/attention. |
|
P337+313 |
If eye irritation persists get medical advice/attention. |
|
P301+P310 |
IF SWALLOWED: Call a POISON CENTER and get medical advice/attention |
|
P405 |
Store locked up |
|
P501 |
Dispose of contents/container in accordance with local/regional/national/international regulations |
Section 3. Composition/Information on Ingredients
|
Component Name |
CAS Number |
EC Number |
Percentage |
|
Water |
7732-18-5 |
231-791-2 |
Balance |
|
Synthetic Isoparaffinic Hydrocarbon |
64742-48-9 |
265-150-3 |
10-28% |
|
Amino-Alkoxy Dimethylsiloxanesiloxane |
71750-80-6 |
N/A |
4-8% |
|
Polydimethylsiloxane |
63148-62-9 |
N/A |
3-5% |
|
Acrylic Polymer |
9003-01-4 |
N/A |
1.5-2% |
|
Quaternary Ammonium Compounds, Bis(hydrogenated tallow alkyl)dimethyl, Salts With Bentonite |
68953-58-2 |
273-219-4 |
0.5-1% |
|
Quartz |
14808-60-7 |
238-878-4 |
<0.3% |
Section 4. First Aid Measures
Eyes: Flood with large amounts water at least 20 min.; get immediate medical attention if irritation persists. Can cause irritation, redness, tearing, and blurred vision.
Skin: Flush exposed area with water. Remove all contaminated clothing. Prolonged or repeated contact can cause moderate irritation.
Inhalation: If affected, remove individual to fresh air. If breathing is difficult, administer oxygen. If breathing has stopped, give artificial respiration. Keep person warm, calm, and get medical attention.
Oral: If swallowed, induce vomiting. Vomiting can be induced with syrup of Ipecac. Give fluids until the vomitus is clear. Get medical attention.
Section 5. Fire Fighting Measures
Flash Point: 200°F
Autoignition Temperature: Not determined
Flammability Limits in Air: Not determined
Extinguishing Media: Carbon dioxide (CO2) water spray. Dry chemical foam can be used to cool fire-exposed containers.
Fire Fighting Procedure: Self-contained breathing apparatus and protective clothing should be worn in fighting fires involving chemicals. Evacuate area in case of overheating or fire. Vapors are heavier than air and may travel to a source of ignition and flash back. Static electricity will accumulate and may ignite vapors.
Hazardous Decomposition Products: May form toxic material, carbon dioxide, carbon monoxide, various hydrocarbons, etc.
Section 6. Accidental Release Measures
Containment/Clean Up: Sections 13 and 15 of this MSDS provide information regarding certain Federal and local requirements. Collect for disposal. Clean up remaining materials from spill with suitable absorbent. For large spills provide diking or other appropriate containment to keep material from spreading. If diked material can be pumped, store recovered material in appropriate container. Clean area as appropriate as some silicone material, even in small quantities, may present a slip hazard. Final cleaning may require steam, solvents or detergents. Observe all personal protection equipment recommendations described in Sections 5 and 8 of this MSDS. Observe all Federal and government regulations that may apply to the cleanup of this material.
Section 7: Handling and Storage
Handling (Personnel): Avoid contact with strong oxidizing agents. Spilled substance increases risk of slippage.
Storage: Keep container tightly closed.
Section 8: Exposure Controls and Personal Protection
Engineering Controls:
Local Exhaust: Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below TLV(s).
General exhaust: Recommended
Personal Protective Equipment for Routine Handling:
Eyes: Use proper protection – safety glasses as a minimum. An emergency eye wash station should be accessible to the work area.
Skin: Washing at meal time and end of shift is adequate.
Suitable Gloves: butyl rubber protection gloves
Inhalation: If spraying or other operations that generate an aerosol mist are conducted, respiratory protection for exposed personnel is recommended.
Precautionary Measures: Avoid eye contact.
Section 9: Physical and Chemical Properties:
|
Physical Form: |
Cream Liquid |
Viscosity: |
Not determined |
|
Color: |
Yellow |
Melting Point: |
Not determined |
|
Odor: |
Banana |
Boiling Point: |
Not determined |
|
Specific Gravity @ 25C: |
Not determined |
Flash Point: |
200° F |
|
Solubility in Water: |
Soluble |
Vapor Pressure @ 25° C |
Not determined |
|
VOC content (% by weight) |
12-20% |
pH: |
7 |
Section 10: Stability and Reactivity
Chemical Stability: Stable
Hazardous Polymerization: Will not polymerize
Conditions to Avoid: None known
Materials to Avoid: Strong acids, strong oxidizing agents and strong reducing agents.
Section 11: Toxicological Information
Acute Toxicity: Irritation to eyes and skin
Chronic: Unknown
Eyes: No data available
Skin: No data available
Sensitization: Not a known sensitizer
Mutagenicity: No evidence for mutagenicity
Carcinogenicity: Contains no ingredients classified as carcinogens by IARC, NTP or OSHA
Reproductive Toxicity: No known reproductive toxicity
Target Organs: None known
Aspiration Hazard: No data available
Section 12: Ecological Information
Fish: No data available
Daphnia: No data available
Algae: No data available
Section 13: Disposal Considerations
Landfill and/or incinerate where permitted in compliance with all applicable Federal, State and local government regulations.
Section 14: Transportation Information
DOT (US)
Not dangerous goods
IMDG
Not dangerous goods
IATA
Not dangerous goods
Section 15: Regulatory Information
|
Contents of this MSDS comply with the OSHA Hazard Communication Standard 29 CFR 1910.1200. This product has been classified according to the hazard criteria of the CPR and the MSDS contains all the information required by the CPR. |
|||
|
TSCA Status: |
All chemical substances in this material are included on or exempted from listing on the TSCA inventory of chemical substances. |
||
|
EPA SARA Title III Chemical Listings |
Section 302 Extremely Hazardous Substances |
None |
|
|
Section 304 CERCLA Hazardous Substances |
None |
||
|
Section 312 Hazard Class |
Acute |
No |
|
|
Chronic |
No |
||
|
Fire |
No |
||
|
Pressure |
No |
||
|
Reactive |
No |
||
|
Section 313 Toxic Chemicals |
None |
||
|
Supplemental State Compliance Information |
None |
||
Section 16: Other Information
The information accumulated herein is believed to be accurate but is not warranted to be whether originating with the company or not. Recipients are advised to confirm in advance of need that the information is current, applicable, and suitable to their circumstances. Any material supplied is the sole responsibility of the user. All materials may present unknown health hazards and we cannot guarantee that the hazards listed herein are the only hazards that exist.